Disassembly and Assembly of the Roborock S7 MAXV

I had to email Roborock in order to get this video with instructions for disassembling my Roborock S7 MAXV robot vacuum/mop combo. I think that access to content needed in order to repair your own devices should be freely available, so I'm uploading for everyone else to use. I will remove the video if/when I see that Roborock has published it themselves. 0:00 Introduction 0:40 Remove battery cover 0:49 Remove side brush gearbox 0:59 Remove front bumper assembly 3:08 Remove main brush gearbox 3:30 Remove motherboard 4:41 Remove visual sensor 4:54 Remove charging decorative piece component 5:13 Remove cliff sensor wires assembly 5:36 Remove omni-directional wheel 5:45 Remove main wheels 6:39 Remove wash detection switch 7:02 Install wash detection switch 7:19 Install main wheels 8:12 Install omni-directional wheel 8:17 Install cliff wires assembly 8:38 Install Ultrasonic Carpet Recognition Module 8:44 Install charging decorative piece component 8:57 Install visual sensor 9:07 Install water tank detection wires & front bumper assembly 10:02 Install motherboard 10:49 Install WiFi antenna 11:02 Install reset & dustbin detection board & wires 11:21 Install rear recharge sensor assembly 11:38 Install fan & Install air-duct 12:28 Install vibrating mopping module 12:52 Install keyboard 13:45 Install front bumper assembly 14:03 Install side brush gearbox 14:12 Install battery cover 14:34 Install LDS protective cover 14:42 Install top cover assembly