Toyota Corolla Serpentine Belt Change, 2ZR-FE Engine, 2010,2011,2012,2013,2014,2015,2016,2017,2018

Replacing the serpentine drive belt on a 2014 Toyota Corolla with a 2ZR-FE Engine. I show how to remove the belt and install the new belt, then adjust the tension with a Krikit tension gauge. Amazon Affiliate Links As an Amazon Associate I earn from qualifying purchases. If you place an order, thank you for supporting my channel! 00:00 Intro 00:15 Disconnect Battery 00:25 Remove Plastic Cover 1:23 Remove Engine Cover 1:30 Remove Serpentine Belt 3:03 Old Damaged Belt 3:18 Clean Pulley Deposits 3:55 Test Bearings 4:07 Install New Serpentine Belt 5:16 Torque Alternator Bolts 6:11 Start Engine & Drive 15 Minutes to Stretch Belt 6:38 Check Belt Tension After Driving 7:07 Tension Range for Used Belt 7:22 Adjusting Tension 7:58 Krikit I VS Krickit II ⚠️ DISCLAIMER: Use of the information in this video is solely at your own risk. The creator of this video assumes no liability for any property damage, injury or expenses incurred as a result of any of the information contained in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. The creator of this video makes no claims, promises or guarantees about the accuracy, completeness, or applicability of the procedures and instructions contained in this video. Any injury, damage, or loss that might occur as a result of improper application, improper use of tools or equipment, or from the information contained in this video, is solely the responsibility...