Li-ion/LiFePo4 Battery Protection 100A BMS 3S 4S 5S 12V 16.8V 21V With Balance Charging Module.

Hi guys ! You may remember that we talked about battery management systems to be used with li ion batteries in a previous video. When creating a battery pack using lithium batteries, a suitable battery management system or a BMS module must be used. . So today we will talk about a BMS module which is operated by bm3451 single controlling ic in this video. ---Description--- 1. This protection board is 3s 4s 5s in common use LiFePo battery protection board 2. specific chip, stable performance, support disconnect protection, over-current protection, over-current protection, overload protection, with balancing, etc. 3. Common use for "same port" and "different port", the protection board uses 15 ultra-low resistance high-power MOS tubes (discharge of 8, recharge of 7), in the same port mode can support the current of discharge 60A, recharge current 60A; 4. Can be used for LiFePo batteries, battery packs etc. ---Parameter--- Single cell battery boost protect voltage: 3.61-3.69V Single cell battery overcharge protect recovery voltage: 3.5-3.6V Overload protect delay: 1.5-2.5S Single cell battery over discharge protect voltage: 2.27-2.43V Single cell battery over discharge protect recovery voltage: 2.45-2.65V Overload protect current: 100A Overcurrent protect current: 100A Overload protection delay: 0.5-1.5S Temperature Protection: Yes, have temperature control interface. Unplug protect: yes Deficiency protect: yes Shortage delay: 100-600uS Lack protect recovery mode: load...