OpenWRT - Install OpenWRT on D-Link DIR-842

In this video, I will show you how to install OpenWRT on the D-Link DIR-842. I am using the hardware version C2 but you can apply this guide on the C1 and C3 version. At the same time, this guide will also work for other D-Link routers which has a Firmware Recovery GUI a.k.a Emergency Web Interface. Please read the instruction carefully, you can brick the router ### First of all, we will need to put the router into the Factory Firmware Recovery mode by pressing the Reset button while turning the router. Once the router is in the recovery mode, the power LED will blink once every second. After that, acess the web GUI to upload the factory.bin firmware. Do not power-cycle (reboot) the router at this time. Once the router is flashed to OpenWRT, we will need to flash the sysupgrade.bin, which can be done via LuCI or SSH. Video timeframe: 00:00 - D-Link DIR-842 OpenWRT Installation - Define the Dardware Version 00:49 - Put the DIR-842 into Firmware Recovery mode 02:39 - Download the firmwares 03:06 - Access D-Link Firmware Recovery GUI 05:10 - Upload the factory.bin firmware to the router 06:55 - Change the network interface IP address 08:38 - Connect to the router via SSH & Install LuCI 11:10 - Install the sysupgrade.bin firmware via LuCI 13:30 - Connect to the router via SSH & Install LuCI (again! ) 16:19 - OpenWRT is running on DIR-842 C2 17:25 - Configure WiFi (Wireless) on the router 19:50 - Learn more about OpenWRT? Thank for watching and see you in the next video!