Laser Cutting Gas Setting | CypCut Setting | Gas DA Correction

The video tells the laser cutting gas setting, you could find the cypcut setting, gas da correctionn steps and other necessary guidance for the problem that parameters setting in cypcut is not matched to proportional value. Here is a matter of configuration. As of now, all factories will most likely equip proportional valves for oxygen, but proportional valves for nitrogen are not a universal configuration, because there will be additional cost. So, if you need the nitrogen proportional valve, it is better to confirm with the supplier. As an extra extension, this function is matched with the gas proportional valve, and we need to set it her only for the gas with the proportional valve. Why do we need this function? It is to be able to control the gas more precisely, provided that we are equipped with a proportional valve for the gas. When the proportional valve is used to control the outlet air pressure of the gas, CypCut will make the DA ports output the corresponding voltage according to the air pressure value set by the user, so that the proportional valve opens at a corresponding angle. Ideally, the voltage range of DA port should correspond linearly to the gas maximum pressure. For example, if the DA voltage range is 0-10V and the maximum oxygen pressure is set to 10Bar, the correspondence between the DA voltage and the oxygen pressure is 1V corresponding to 1Bar, that is, when the air blowing pressure of oxygen is set to 1Bar in CypCut, the DA output voltage is...