DTC KIA C1210 Short Explanation

Аватар автора
Школа Драйвинга
The video focuses on the basic KIA diagnostic error code. Contents: 0:21 Basic DTC analysis according to OBD2 protocol standard. 1:48 Insight into programming - an explanation of what a bit is and how a byte is formed - decoding the Error Code to the base programming 2:58 A diagnostically understandable description of the Diagnostic Trouble Code 3:05 Basic error definition - Possible causes or errors of the car and its parts describing the mentioned error We will continue to work on improving the content. Our efforts at Maxidot s.r.o.the video content gets better. #kia Make: Kia Code: C1210 Definition: Class 2 Circuit Short to Ground Description: Key on or engine running;system voltage supplied to the module is in the normal operating voltage range,vehicle power mode requires serial data communication to occur,and the ECM did no detect any valid messages on the Class 2 circuit,or the voltage condition detected on the Class 2 circuit was low for 3 seconds.Modules connected to the Class 2 circuit check for data communications during normal vehicle operation.Operating information and commands are exchanged among the modules.Each module transmits Node Alive messages on the Class 2 data circuit once every 2 seconds.When the module detects a low voltage condition on the Class 2 serial data circuit for approximately 3 seconds,it sets U1300 or U1305 if it cannot identify the problem.Note: This code is set by loss of communication.Look in All of the modules for this trouble code...

0/0


0/0

0/0

0/0