????? ???????? ????????? ??????? | ????? ?? ?????? | ?????? ?? ????? | ??????? @FlowChart

Аватар автора
Техно-революция
????? ???????? ????????? ??????? | ????? ?? ?????? | ?????? ?? ????? | ??????? @FlowChart Transferring parameters to other standard devices Parameter settings can be easily copied from one standard device to another by using the keypad. For this purpose use the "Load/Store" menu Danger! During the parameter transfer from the keypad to the standard device the control terminals can adopt undefined states! Therefore the plugs X5 and X6 must be disconnected from the standard device before the transfer takes place. This ensures that the controller is inhibited and all control terminals have the defined state "LOW". Note! After copying the parameter sets into the XT keypad (C0003 = 11), always the parameter set that was loaded last via C0002 is activated. Like this the current parameters also remain active after copying: Save the current parameters in the parameter set before copying and load this parameter set in the controller via C0002. Copying parameter sets from the standard device into the keypad Step Key sequence Action 1. Connect the keypad to standard device 1(INVERTER) 2. Inhibit controller Terminal X5/28 = LOW The drive coasts. 3. Select C0003 in the "Load/Store" menu , Select code C0003 "PAR SAVE" in the "Load/Store" menu using the arrow keys. 4. Change to the parameter level PRG Display "0" and "READY" 5. Copy all parameter set into the keypad ^ The settings saved in the keypad are overwritten. Set "11" "Save extern" 6. Start copying SHIFT+PRG The "RDY" status...

0/0


0/0

0/0

0/0

Скачать популярное видео

Популярное видео

0/0