XK Wltoys A160-J3 SKY LARK - GREAT RC airplane READY TO FLY for beginners - assembly and flight tes

Аватар автора
Радиоуправляемые танки: стратегия и тактика
RC Airplanes - XK A160-J3 SKY LARK - The most beautiful low-cost stabilised RC Plane for BEGINNERS - IT FLIES VERY WELL - This tiny Piper j3 cub is the same as the real one and flies well too-assembly and flight test - scale model - Tipstall problem solved, change the position of the receiver antenna away from metal rods as far as possible, add or replace the esc capacitor with a 350 μF 16 volt.. The capacitor is needed to stabilize the voltage and to reduce power spikes. When there is a change of the speed of the brushless motor, the esc receives a lot of voltage spikes( due to the black EMF effect ), this can cause a brownout of the voltage regulator for the microprocessor or for the gyroscope(which is very sensitive to voltage fluctuations). Hello everybody. Ok guys, I deeply tested this airplane. This model can&fly with medium, strong or gusy wind in stabilized mode, in 6g mode it can ONLY fly with no wind or a light breeze, otherwise it will go into a flatspin because the flight controller3 isn&able to make the plane to back to level in the event of a snap, strong yaw movement of stall(probably due to the lack of pitch throw), this doesn&happen if there isn&any wind. The center of gravity is spot in, every plane in this scale need as bit of throttle in order not to stall at low speed, in particular this is a scale reproduction that has an airfoil similar to the real one(a flat bottom airfoil). Usually some manufacturers like Eachine use a under-camber in order to...

0/0


0/0

0/0

0/0