Tutorial：How to Plug and Glue the XP600 Printhead?

(Новая Оригинальная головка принтера Epson xp600 для epson DX6 DX11 Запчасти для принтера) Внимание! Если ссылка ведет не на тот продукт, что Вы искали, воспользуйтесь поиском по сайту! How to Plug and Glue the XP600 Printhead? 1. First, take protective measures for the nozzle. Using three short lengths of hose, insert the hoses into two adjacent sockets respectively. This action is to prevent air leakage and cause blockage of the nozzle in the later stage. 2. Install the nozzle cable. QR code is the standard. 2 and 3 on the left, 1 and 4 on the right. The two lines are symmetrical. Make sure to distinguish between the left and right when installing the cable to prevent the nozzle from burning. Before installing the cable, check whether the socket has water stains or ink. If the water stains or ink are not cleaned up in time, it may be burned directly when the machine is installed or glued. In the process of plugging in, the action should be gentle and a little slow, and do not plug the cable crookedly. After the first cable is inserted a little, then pull it out. Test it on the palm of your hand to see if there is any water or ink on the plug. If there is, please use a fan to dry it first. This step is to confirm whether the cable outlet is clean. If there is no water stains or ink, you can continue to insert the cable. During the process of inserting the cable, insert it slowly and do not use excessive force. Excessive force will damage the cable outlet. Finally, make...