Bigtreetech Ender 5 Plus Upgrade: SKR Mini E3 V2.0 (Part 3)

Now it&time to take a look at the first Bigtreetech board, the SKR Mini E3 V2.0. In this video, I walk through the pin-out diagram and show you how I connected the Ender 5 Plus to this board with minimal wiring changes. You can also find my pre-configured firmware and config files below. #marlin Product Links: Please note that Amazon occasionally changes their listings. Please verify the product is correct before ordering. Documentation: Firmware Files (Updated: 2021/07/20): Marlin 2.0.9.1 Ender 5 Plus SKR Mini E3 V2.0: SKR Mini E3 V2.0: How-to Flash: 1. Just copy the correct .bin file to the microSD card and rename it firmware.bin. 2. Power cycle the machine. 3. When it boots back up it should flash the firmware. 4. The splash screen should now say 2.0.6 as the version. If you look at the microSD card contents it will have a firmware.CUR and not a firmware.bin. SUCCESS! For Amazon Links: As an Amazon Associate I earn from qualifying purchases. Other purchase links may also be affiliate links. You can support my work monthly on Patreon: You can support my work via one-time PayPal donations: Where to find me on Social Media: Credits: Opening Music: –––––––––––––––––––––––––––––– Creative Commons - Attribution-ShareAlike 3.0 Unported - CC BY-SA 3.0 ––––––––––––––––––––––––––––––