Solder a SMA socket to an ESP32 for a external antenna - ESP32 Harici Anten Bağlama

Аватар автора
Технологическое преображение сегодня
The video shows how to solder an SMA socket connector to an ESP32 to used with a external antenna. Theres a few things I want others to know if they watch this. 1) NEVER TURN your devices on without an antenna attached! This will burn up the radio... 2) The soldering work in this video shows exactly how not to solder. When dealing with radios, its VERY important to take care with your solder. Too much is a bad thing, wrong tips is also a bad thing, and of course too little is bad. In this case, the author uses too much solder while tinning and then has to apply a lot of heat to get the solder to spread out. This will cause problems that you will not be able to figure out. Low signal, dropped packets. With that said, good video on how to add an antenna to an ESP32. Başkalarının bunu izleyip izlemediklerini bilmelerini istediğim birkaç şey var. 1) Cihazınızı ASLA anten takılı olmadan çalıştırmayın! Bu radyoyu yakar ... 2) Bu videodaki lehimleme işi tam olarak nasıl lehimlenmeyeceğini gösterir. Radyolarla uğraşırken, lehiminize dikkat etmek ÇOK önemlidir. Çok fazla kötü bir şey, yanlış ipuçları da kötü bir şey ve tabii ki çok az kötü. Bu durumda, yazar kalaylama sırasında çok fazla lehim kullanır ve daha sonra lehim yayılması için çok fazla ısı uygulamak zorundadır. Bu, çözemeyeceğiniz sorunlara neden olacaktır. Düşük sinyal, bırakılan paketler. Bununla birlikte, bir ESP32&nasıl anten ekleneceğine dair iyi bir video.

0/0


0/0

0/0

0/0