Mach3 MPG Wiring and Full Config

MPG (Handwheel) wiring and configuration needed in Mach3 , I have Red 4 axis mach3 board and standard handwheel. Mach3 Red handwheel 10 socket port: +5v | o o | GND X | o o | Y ACH o o | BCH Z | o o | A X100 | o o | X10 Standard MPG with ESTOP Wire Colors: (Red - Green/black) -- 5v (Black - White/Black - Orange/Black) -- GND (Yellow) -- X (Yellow/Black) -- Y (Green) -- A CH (Encoder) (White) -- B Ch (Encoder) (Brown) -- Z (Brown/Black) -- A (Orange) -- X100 (Gray/Black) -- X10 (Blue & Blue/Black) -- IN1 & DCM in BOB _____________________________________________________ 2- Config -- ports & pins -- Input signal: OEM Trigport -- 3 , pin -- 5 OEM Trigport -- 3 , pin -- 6 OEM Trigport -- 3 , pin -- 7 OEM Trigport -- 3 , pin -- 8 OEM Trigport -- 3 , pin -- 9 OEM Trigport -- 3 , pin -- 10 _____________________________________________________ 3- Config -- ports & pins -- Encoder/MPG's: Encoder1 -- Enabled MPG-- Enabled _____________________________________________________ 4- Config -- System hotkeys: Trigger 1 -- oem code 185 To select X axis Trigger 2 -- oem code 186 To select y axis Trigger 3 -- oem code 187 To select z axis Trigger 4 -- oem code 188 To select a axis Trigger 5 -- oem code 192 To select x10 jog step Trigger 6 -- oem code 193 To select x100 jog step _____________________________________________________ 5- Config -- General Config... -- Jog Increments in cycle Mode: Position1 -- 1...