Doomsaw HM-2 Heavy Metal Chainsaw Distortion from Does It Doom

Our latest collaboration with Nick Williams of Dunwich Amplification, the Doomsaw is a gruesome single knob adaptation of the dimed HM-2 chainsaw circuit. We’ve taken the classic death metal tone and tailored it to modern doom, sludge, and drone metal. Thundering lows, punishing mids, and that unmistakable chainsaw grind, the Doomsaw is a visceral device designed specifically for downtuned guitar and bass. The traditional HM-2 Level, Low EQ, and High EQ settings are maxed internally, with the single Grief knob controlling Distortion. An increased and extended Low EQ combines with a modified High EQ for a pummeling chainsaw dirge with reduced high frequency harshness. Controls Grief: Distortion. Set the Grief knob towards zero and run the Doomsaw gyrating EQ into a high gain amplifier or your favorite fuzz / distortion pedals. Set the Grief knob towards max and run it as your primary distortion pedal for unrivaled dimed Doomsaw fury. Power Use only a standard 9v DC power supply with a 2.1mm negative-center barrel. An isolated power supply is recommended. Power supply not included. 00:00 Intro 0:23 Collaboration with Nick Williams of Dunwich Amps 0:48 Doomsaw control and specs 1:18 Doomsaw vs. Boss HM-2 2:00 Where to get a Doomsaw 2:20 Jon Davis of Conan&chainsaw guitar tone 3:39 Conan - Volt Thrower (Drop F, Grief at 12 o&Green Matamp GT120MV) 4:18 Conan - Prosper On The Path (Drop F, Grief at max, Green Matamp GT120MV) 5:02 Electric Wizard - Supercoven...