*UPDATED* TP-Link Router Wireless Bridge Setup. How to configure Enable WDS Bridging Archer

In TP-Link&WDS Bridging setup configuration document they leave out a crucial step and the router is not fully setup until you complete one last step in the process. At the end of this document there should be another step calling out the IPTV/VLAN section where the "Enable IPTV/VLAN" box must be checked, the "Bridge" Mode must be set and the LAN ports 1-4 must be set to "Internet". Without this step you will only be transmitting a wireless signal from your Tp-Link router, but the ethernet LAN ports 1-4 will not be functional. Hardware Model: Archer A6 V2.0 Firmware: 1.1.8 Build: 20210226 This comment might help some of you. it is pinned in the comments section as well. Send your thanks to them. @alitaherimoghadam8894 Hi Mike, thank you for the video and saving us a lot of time! For those who are asking about losing access to the tp-link router/ bridge after saving the setting, I was in the same boat but I found this simple solution to work. I checked the IP range the main router with internet access uses for dhcp, and assigned the tp-link bridge with something within that range rather than sticking with default 192.168.0.x range as shown on the video. That&it! many home routers use default subnets like 192.168.100.0/24, or 10.10.10.0/24. in this case my home router uses 192.168.1.0/24 range, so I assigned an un-used IP in that range to the tp-link bridge - lets say, 192.168.1.188/24. This allows you to still connect to the tp-link router even when its in...