Woodworking With Resin

Woodworking With Resin will show how to pour Casting Epoxy, prep live edge slabs, finish woodworking projects, apply seal coats, use metallic powders to enhance our epoxy with metallic powders. This throwaway Redwood was salvaged and hand made into functional art. Color Recipe: Plane your wood with SCC Slab jig. Assemble your mold and put tyvek tape down in the mold, apply the tyvek tape onto the outside of your mold to create a good seal as well. Apply a seal coat to the edges of your wood with SCC Quick coat gap and seam filler. Torch to remove air bubbles. Mix SCC Super cast by hand to minimize air bubbles. Split into 2 containers and tint one with SCC Purple mountain metallic powder, tint the other with SCC Violet pearl metallic powder. Pour as desired 1/4" at a time, taking a torch to remove any air bubbles before pouring your next 1/4". You can pour up to 2" in a 24 hour period with our Super cast. When project has hardened remove it from your mold. Sand the surface smooth and flat by hand or use your router with SCC Slab jig. Work from 60 grit up to 220 grit sand paper with an orbital sander. Router the edges using 1/4" round over bit on the top of the edge and 1/8" round over on the bottom of the edge. Use SCC Quick coat gap and seam filler epoxy to seal the project. Mix 1:1 ratio, at an amount of 1oz of mixed epoxy per square foot and apply with a shower squeegee for your seal coats. Torch 3x to remove air bubbles. After 3 hours sand with 220 grit to open any...