Audi SEAT Skoda VW 2.0 TDI Intake Inlet Manifold P2015 Error Flap Actuator Motor Bracket

The Problem P2015 error caused by over rotation of the actuator motor on the intake manifold. If your vehicle has a P2015 error it is very likely the main dealer will look to fix this issue with a complete new intake manifold which can cost £700+. The fault however usually lies with the actuator motor on the intake manifold. There is a small plastic limiting stop on the butterfly assembly within the manifold which this motor operates. This is delicate and inevitably wears and causes the actuator motor (V157) to over rotate triggering the P2015 error or associated symptoms. Our repair bracket can be installed very easily providing a solid limit for the actuator motor- curing this fault for the life of the vehicle. There is no need to replace the complete manifold / actuator motor which would only fail again. Symptoms of the fault P2015, Implausible Signal - MIL ON, VAG 8213, P2002, P2009, P2015, P2017. Engine management light lit or limp mode. Intermittent or constant CEL (check engine light) DTC 2968, 18447, 008213, Intake manifold flap position sensor fault. Vehicles affected and compatibility ALUMINIUM MANIFOLD: VAG 2.0 TDI four-cylinder common rail engines 2008 - 2014 with aluminium manifold. Not suitable for V6 TDI or 2.0 Petrol Turbo engines. Part number 03L129711E with V157 actuator motor only. Fitment will vary by region. Please check manifold part number on the vehicle. Volkswagen Amarok, Beetle, CC, Eos, Golf, Jetta, Passat, Scirocco, Tiguan...