Anycubic Mega X 3D Printer Setup and Review

Thank you so much for watching! See what else I am working on: #Anycubic *These are the settings I used for my Anycubic Mega X 3D Printer with White PLA. These settings are not going to work with every printer, or every PLA. Printers have different length bodin tubes, and PLA’s have different melting points. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck! LW-PLA Temp 235c Flow 55% Retraction Distance – 2 Retraction Speed – 30 Retraction Extra Prime Amount – 0.3 All other settings the same as bellow: Profile 3 Cura Settings: Quality: Layer Height – 0.25 Line Width – 0.4 Shell: Wall Line Count – 1 Infill: Infill Density – 0 Material: Printing Temperature – 215 Build Plate Temperature – 60 Flow – 100 Speed: Print Speed – 100 Outer Wall Speed – 35 Inner Wall Speed – 35 Travel Speed – 80 Travel: Enable Retraction – Checked Retraction Distance – 4 Retraction Speed – 30 Retraction Extra Prime Amount – 0.4 Combing Mode – off Cooling: Enable Print Cooling – Checked Fan Speed – 80 Mesh Fixes: Union Overlapping Volumes – NOT Checked Special Modes: Surface Mode – Surface Experimental: Slicing Tolerance – Middle Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This...