How to Replace the Cutter of the HP DesignJet T120/T520, T100/T500 & T730/T830 Printer Series | HP

Learn how to remove and replace the cutter in an HP DesignJet T120, T520, T100, T500, T730, and T830 printer series. Chapters: 00:00 Introduction 00:16 Remove the Cutter 00:32 Insert the New Cutter 00:59 Insert Roll of Paper 01:03 Select Form Feed & Cut Continue the Conversation: Follow these steps to remove and replace the cutter in an HP DesignJet T120, T520, T100, T500, T730 and T830 printer series: - Turn off the printer. - Open the ink cartridge cover. - In the T730 and T830 models, you will need to remove a screw. - Pull down the blue lever. - Remove the cutter. - Insert the new cutter, making sure the two white gears are engaged under the rack. - Move the cutter to the center of the printer. - If it is blocked, remove it and insert it again. - Push the blue lever until it clicks into place and close the ink cartridge cover. - In the T730 and T830 models, you will need to reinstall the screw. - Turn the printer on. - Make sure that a roll of paper is loaded in the printer. - Press the setup icon and select Form feed & cut. #HPDesignJet About HP: HP Inc. creates technology that makes life better for everyone everywhere — every person, every organization, and every community around the globe. Through our portfolio of printers, PCs, mobile devices, solutions, and services, we engineer experiences that amaze. Connect with HP: This video was produced by HP. How to Replace the Cutter of the HP DesignJet T120/T520, T100/T500 & T730/T830 Printer Series | HP