Sikkens Cetol HLS Plus | Sikkens HLS Plus Low Build Basecoat and Wood Stain

Sikkens cetol HLS Plus is a low build satin basecoat and wood stain for most exterior woods. It can be used as both a basecoat and a finishing coat depending on the project you are doing. It is resistant to UV, surface mould and algea, peeling and cracking. The wood grain remain visible and it can be over coated with Sikkens Cetol Filter 7 Plus. It is an ideal product to use on softwood, hardwood ,plywood, block board and partical board, such as cladding, fascias, archatraves, timber frames, fences, and sheds. Preparation Wood to be treated with Sikkens Cetol HLS Plus should be clean, dry and free from surface dirt, debris and surface coatings such as paint or varnish. Degrease any exposed bare timber surface by wiping with a cloth dampened in a suitable solvent. The use of &agents&is not recommended with translucent finishes as they are not always fully effective in sealing in resin, the presence of knots is often highlighted and adhesion of coatings can be impaired. When filling, be sure to use fillers specifically designed for use with timber. General or all purpose fillers may not be suitable. Applying Sikkens HLS Plus Always do a test area before starting any project to test adhesion and final finish. Follow the manufacturer&instructions on the tin at all times. Ensure that Sikkens Cetol HLS Plus is stirred thoroughly before and periodically during application use to ensure a consistent finish. Application temperature should not be below or exceed 5 - 30℃...