HOW TO SET UP & USE NIDECKER SUPERMATIC BINDINGS

Available Fall 2022, the Nidecker Supermatic bindings are the first snowboard bindings that offer automatic entry any boot and can still be used as a single-piece two-strap binding. In order to get the most from Nidecker Supermatic step in snowboard bindings, it&important to set them up correctly for your snowboard boot: - Start by locking the heel pedal all the way down with the highback in its upright riding position - listen for the clicks as you do so. Loosen the strap on both sides and place your boot into the binding. - Align the ankle strap so that it sits centrally over your boot. Lock the inner ladder into place, then adjust the ratchets so that it’s snug, but not too tight. Do the same for the toecap strap. - Now attach the middle ladder and fit it so that there’s a slight gap between it and the boot. Its function is to keep the straps in place, and it’s important that it’s not tight or sitting against the boot. - Once the straps are fitted, click down the Locking Slap Ratchets to keep them in place and save your settings. If you can see the red markers, the ratchets aren’t secured yet. - Finally, remove your boot from the binding by pressing down on the release lever, raising your heel and sliding your foot out. Now you’ll be able to slide your boot back into the binding and lock it into place. The Slip ‘n’ Grip plates on the footbed and highbacks, as well as the heelcup roller, make this easy in any snow conditions, and the ExoFrame straps ensure that snow...