Subaru Legacy Outback - AIRBAG CONTROL MODULE REMOVAL / REPLACEMENT (2003 - 2009)

Step-by-step guide on how to remove / replace / change SRS airbag control module on Subaru Outback or Legacy ( 2003 | 2004 | 2005 | 2006 | 2007 | 2008 | 2009 | 2.5I | PZEV | 3.0 R). Main SRS airbag control module controls airbag&deployment and stores crash data and is a very often fail on this older generation Subaru Outback / Legacy. Give me your support and join the channel: To remove the air bag control module, you will have to remove couple of things. Start by removing the middle console. Then you will have to remove the radio and climate controls. After that side trim panels and then you will gain full access to screws which are holding the airbag module. Good luck. Thanks for watching. I hope this video was helpful. If it was, don&forget to Like it / SUBSCRIBE to the channel! ⚠ DISCLAIMER: While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual...