How to build a Pug V2 DLG RES V-Tail from angel wing designs part 1 intro and fuselage

Аватар автора
Make Money on in
Well welcome back to Pug V2 from www.angelwingdesigns.co.uk part 1 is an intro about the improvements and the fuselage build. This glider can be built as a DLG ,Res , V-tail, Pug V2 Design Goals (1) Further Improve the overall Build experience (2) Reduce the sanding and weight of the wing tips (3) Improve Rudder response (4) Enhanced wing section (5) Totally re-imagine the canopy hatch Changes: (1) Enhanced wing section (2) Increased Dihedral (3) Replaced the trailing edge with carbon fibre rod (4) Increased the number of ribs to reduce covering sag. (5) Reduced amount of centre Sheeting and tip weight (6) Removed need to drill and tap the wing hold mounts (7) Resin Printed Canopy magnet retainer (8) Resin printed wing hold downs with steel nut (9) Resin printed pushrod guides (10) Resin Printed Tail plane mount (11) Overall reduction in sanding (12) Optional RES fin for Bungee launching (13) Optional V Tail for Bungee and slope (14) Separate colour wing plan for both wing halves (15) Full PDF instruction manual

0/0


0/0

0/0

0/0