How to build your own octocopter, frame build and electonics fitting.

full tutorial All required parts are listed below hobbking x930 frame 8 x 30Amp esc&any make or brand, just make sure they are 30Amp not 25 with 30burst. 30 bullet connector pairs 2.5mill or higher. 20pais of xt60 battery cnnectors 8 meters of silicone wire- 4 meters red - 4 meters black 26swg which is 3mm thick or more. solder- preferred leaded. 8 x 12x4.7 props 4 clockwise 4 counter clockwise (order spares!) 8 x 850/750/700 kv outrunner motors bell type lots of various sized shrink tubing. (Radio) Turnigy 9xr Frysky Jr module with telemetry RX 2 x frsky voltmeters (note i am referring to small meters that are less than $5 each they have a red and black wire coming off each end with a servo plug on one end) Male to male servo plugs x 18 Male to female extension leads (any length) x 10 stickyback velcro Above is everything you need to build your own copter. 4x 2200MAH 3s battery or any 2 battery combination that totals at least 8000MAH APM 2.5 flight controller board MAvlink for telemetry (not required) Ublox GPS