Subaru Forester Washer Fluid Reservoir Replacement (2014 - 2018)

How to replace the windshield washer reservoir on a Subaru Forester. This DIY video will show you where the washer reservoir is located on the Forester, the location of the two EW08 Mitsuba pumps and how to remove and reinstall the complete reservoir. Note that the fluid level sensor is not a replaceable part. If you&went to start your Forster and noticed that the low washer fluid light was illuminated, you probably added fluid to the reservoir. If after adding fluid the light is still illuminated, there&a very high chance the sensor in the reservoir has gone bad. In this video will be replacing the windshield washer fluid reservoir. Since the sensor isn&a replaceable item, we need to replace the complete Reservoir. The part number for most 2014 through 2018 Foresters is: 86631SG020. This part number includes the windshield washer Reservoir and the fluid level sensor. Please check out my video on how to remove the Subaru Forester front bumper to gain access to the windshield washer Reservoir. It&a lot easier than you would think! Looking at this Reservoir, you can clearly see that the fluid level it¬ low. Note that the Subaru Forester uses Mitsuba a EW08 windshield fluid pumps. During my inspection, I noticed 1 fluid line had been compromised and when the windshield fluid pumps would run, the line would waste a lot of fluid. The washer Reservoir is held on buy two bolts, one nut and two plastic clips. All of these are easy to get too except for the last Bolt...