HP Designjet Z3200 printer - how to setup & configure your HP Designjet Z3200

Аватар автора
Техника для дома: рекомендации по покупке
Introduction to setting up & installing your new DesignJet. This video features the DesignJet Z3200. What to expect when purchasing a new HP DesignJet. For Sales, Service Support & Advice visit: This video shows how to set-up and configure your new Designjet Z3200 photo printer. We see the machine set up on the stand going through the final removal of the intransit packaging, all orange tape and clips both on and under the cover, on the spindle and the back of the machine. We see, this being a high-end photo printer, the 12 ink cartridges including the gloss enhancer being installed - they are just plugged in and the sensor beeps each time to show they have been recognised by the Designjet. Following the instructions on the panel accepting ok to continue, the Designjet will now prime the tubes by pumping the ink through the system to the dummy printheads - once the machine is happy the tubes have been primed, the dummy (orange plastic) printheads are removed and disposed off. The packaging on the new printheads is removed and and they are inserted as shown - 6 double printheads 2 colours in each- again accompanied by the beeps recognising them as they are installed. Having relatched the printhead cover and closed the top cover the Designjet now checks all the printheads and asks for a paper roll to be loaded ready to print the alignment page . With the roll aligned it prints out a successful alignment page. The next step we see, having a built in LAN card, is the Designjet...

0/0


0/0

0/0

0/0