How to adjust break out table flow | FlexiROC D60 | FlexiROC D65 | SmartROC D60 | SmartROC D65

In this Epiroc 24/7 video, Jon Larson, Technical Trainer for Epiroc, demonstrates how to adjust the breakout table flow on DTH model rigs. Learn the importance of timing between the jaws and how to adjust the flow regulators to ensure accurate alignment of the pipe. Gain valuable insights into maintaining proper flow rate and avoiding potential pipe damage during the operation. Applies to the following models: FlexiROC D60 | FlexiROC D65 | SmartROC D60 | SmartROC D65 #SurfaceRigs Warning: Read and follow all labels and the Owner’s Manual carefully before installing, operating, or servicing unit. Read the safety information at the beginning of the manual and in each section. Disclaimer: Legal Notice © Copyright 2022. All product names in this video are trademarks of Epiroc. Any unauthorized use, broadcasting, transmission, copying or re-recording of the contents or any part thereof is prohibited. Photos and videos may show equipment with optional extras. No warranty is made regarding specifications or otherwise. Specifications and equipment are subject to change without notice. Under no circumstance will Epiroc be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Epiroc or a third party. In no event shall Epiroc be liable for any direct, indirect, punitive, incidental, special...