HP DeskJet 2700 and Plus 4100 Series Unpacking and Setup | HP Printer Setup

HP Printer setup support presents Unpacking the HP DeskJet 2700 and DeskJet Plus 4100 Printer Series _ HP Printers _ HP_1 To set up a printer for the first time, remove the printer from the box, connect the power cord, add printer to HP Smart, load paper, install the ink cartridges, and complete setup. Remove the printer from the box Remove the printer from the box, and then remove all tape, stickers, and packing materials. CAUTION: To avoid setup problems and potential printer damage, make sure all internal packaging material is removed, all doors are closed and trays reinserted before turning on the printer. Remove the printer from the box. Remove all tape and packaging materials from the outside of the printer. Lower the output tray, reach inside the printer, and then grasp the handle and lower the ink cartridge access door to open it. Remove all tape, packaging materials, and cardboard from inside the printer. Close the ink cartridge access door. Remove all hardware and materials from the box. Recycle the box and packaging materials. Connect the power cord Plug the printer into an electrical outlet and turn on the printer. NOTE: Do not connect a USB cable at this time. The connection to the computer is established during the software installation. Connect the power cord to the back of the printer and into an electrical outlet. Press the Power button. Wait until the printer is idle and silent. The steps that follow on this page can be used with the instructions in HP...