HOW TO BUILD A REAR TABLE FOR YOUR SUZUKI JIMNY JB74

Welcome back! In this video I’ll be going through how I built my rear table, the materials you’ll need and what I could have done different. I’m overall quite happy with my table but I am hoping this video will give you a bit more confidence and insight into building your own. I’ve collected all the materials into one list below. Everything can be bought at Bunnings Warehouse in Australia, and I’ve only listed the items I’ve used. Not to mention, I’ve mostly listed the cheapest versions of them. You can of course buy more expensive tools if you’re concerned about them lasting, but these tools should hopefully assist you with more than just building a table for your Jimny. You’ll need the following: • Ozito 810W Pendulum Jigsaw - $69.90 • Ozito 200W Detail Sander - $32.98 • Ozito 3.6V Cordless Screwdriver With USB Changing Base - $34.98 • Project Panel 1200 x 897 x 7mm Premium Grade Radiata Plywood – Price differs (around $30-50 for a plate) • Zenith 50mm Matte Black Fixed Pin Butt Hinge - Pack of 2 - $4.31 • Zenith 4G x 9mm Zinc Plated Self Tapper Pan Head Sheet Metal Screws - 50 Pack - $3.45 • To hold the table up at 90 degrees I used the Grunt 25mm x 10m Polyester Webbing Black - $7.25 • Zenith Nickel Plated Assorted Snap Fasteners - $9.38 – Alternatively you can use tie down straps – I’ve used both just because my table is a bit larger and to avoid it shaking on uneven terrain. Other tiny (but important!) tools you’ll need: • Measuring tape • A pen for...