How to replace LCD Screen on HP EliteBook 840 G6. Step-by-step instructions

This is a guide on replacing a screen on a HP Elite Book 840 G6 For the replacing process we will need the following tools: -a plastic pick -tweezers -and a screwdriver To begin turn the laptop off and disconnect the power cord. Start removing the bezel. The bezel is held in place by tabs and the glue along the inner edge. Using plastic pick pry off the bezel on the inner edge. Start from the left side and move around the perimeter. Using both hands start unsnapping the tabs underneath the bezel. Go along the perimeter. Close the laptop and and turn it over. Using the same plastic pick release the bezel at the bottom of the screen. Remove the bezel. The LCD screen is held in place with screws in four corners. Using Phillips screwdriver remove the screws. Place the screen on the keyboard. Peel off the tape securing the video connector. Using plastic pick open the connector’s bracket. Disconnect the video cable. Remove the screen and place it on the desk top. We need to transfer two metal plates with brackets onto the new screen. Using plastic pick separate the plates. Normally we would use adhesive strips to glue the plates onto the new screen. But in our case the glue is still working. Place the first plate onto the side of the screen and apply some pressure. Attach the second plate. Place the new screen on the keyboard. Reconnect the video connector. Close the connector’s bracket. Secure it with a clear tape. Lift the screen up. Now we can test the new screen.