Converting Gerber Files to G-code Using FlatCAM

This is the second part of a two part instructional video series on how create a custom circuit board using a low-cost CNC router. This second part video uses the open source FlatCAM software generate the isolation routing path, drill paths, and cut-out paths from drill and Gerber files created using Kicad in the first part. G-code files are created from the generated paths ready for a CNC router. I am not an expert in FlatCAM so the techniques shown in this video may not be the most efficient nor most effective approach. Viewers should also note that the CNC parameters used are for a hobbyist 3018 CNC, hence the low RPM and consequently low feed rates used. Software: Music: Arp Bounce - Geographer