How to Tune The Elegoo Neptune 4 Klipper 3D Printer for Better Print Quality (Step-by-Step Guide)

COMMANDS: Run the mesh bed leveling - BED_MESH_CALIBRATE Enable temperature tower - TUNING_TOWER COMMAND=&HEATER=extruder&PARAMETER=TARGET START=200 STEP_DELTA=5 STEP_HEIGHT=5 Run PID tuning Hotend - PID_CALIBRATE HEATER=extruder TARGET=230 Bed - PID_CALIBRATE HEATER=heater_bed TARGET=65 PID value should be formatted this way under the extruder and heater_bed sections: control :pid pid_kp : xx.xx pid_ki : xx.xx pid_kd : xx.xx Pressure advance Run this command first - SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500 Then this command - TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005 #3dprinting