Strobe Controller For LED Stoplight (GS-100A) - How To Install It With Yourself In Pulsar 150CC

What do you want GS-100A Strobe controller for LED stoplight or Same alternative product Tape or Heat shrink sleeves Wire stripper or Small knife How to do it Find the which wire module is for the break system Once you find out clearly then isolate the which triple wire connector is powered by the break system Remove the triple wire socket in both ends and get all 6 wires out of the socket Carefully chose the which one is for the Ground (neutral) usually two colors code (wire has two colors strips) wire is the one you looking for Then carefully chose the which one is for the Parking once you found don&remove the metal chips and attache both ends together with the help of those clips Now you can easily isolate the remaining wire as the break wire Use input side of the controller and attach Ground to Ground and Hot(live wire) to Break wires Use output side of the controller to attach the rest of the wires in other ends direct to the LED light Put all wires inside the module cap and attach it where it used to be That&all you have done.