Hp Laser Jet 404 Dn Dw Unboxing and Configuration Complete Setup Installing

Here&a step-by-step guide to setting up an HP LaserJet 404 DN or DW printer: 1.Unbox the printer: Carefully unbox the printer and all of its components, including the power cord, control panel overlay, and manual. 2.Connect the power cord: Connect the power cord to the printer and then to a power outlet. 3.Install the control panel overlay: Install the control panel overlay, if included, following the instructions in the manual. 4.Install the toner cartridge: Open the printer&front door and install the toner cartridge by inserting it into the correct slot and closing the door. 5.Load paper: Load paper into the input tray by pulling it out, adjusting the guide to fit the paper, and then pushing the tray back into the printer. 6.Connect the printer to your network: Connect the printer to your network by using an Ethernet cable or by using the printer&built-in wireless capabilities. 7.Install the software: Insert the software CD into your computer&CD drive and follow the instructions to install the software. If the CD is not available, you can download the software from the HP website. 8.Print a test page: Once the software is installed, print a test page to ensure that the printer is working properly. Note: The specific steps for setting up an HP LaserJet 404 DN or DW printer may vary depending on your operating system and network configuration. Refer to the manufacturer&manual for more information #Newprinter 00:00 Hp laser Jet M404dn Dw Unboxing 00:26 3 Types of...