I turn a Railroad Track into an Anvil! Simple & Easy DIY - Homemade Anvil (1080p_50fps_H264-128kbit_

As you might know from my Instagram posts, I&recently restored and cleaned my workshop. Under a lot of trash, covered in dust, I found an old railroad track. I had no idea it was there and obviously I had no use for it. For that reason I decided to make a small anvil out of it. I always wanted to have a small one. First I went online and did some research about anvils. After I had an idea how it should look like I started to cut it in shape with the angle grinder. I milled the surfaces flat after a rough shaping with the angle grinder and drilled a hole in it. If you don&have access to a milling machine, you could also grind the surfaces clean with an angle grinder. Having the top surfaces finished I was able to start shaping the horn. First I cut of the biggest pieces with the angle grinder and then I started to shpae the horn. Rough shaping at first with the angle grinder, then smoothing out with a file and then sandpaper. To remove all the rust I decided to give it a quick sandblast. If you don&have access to a sandblaster you could also remove the rust with a wire wheel or just grind it all clean with the angle grinder. For rust protection I used cold bluing. I then sanded all the functional surfaces clean again. This also gave the whole thing a nice touch and some contrast. I&more than happy how it turned out and I can&wait to start using it on future projects. I hope you like my work and the video. Huge thank you to all of my Patreon and PayPal supporters and...