DIY Digital Tone Control Rocking Sound TDA7313 controlled by arduino

#Arduino system #Amplifiers #TDA processor #Electronics #diy #Howto #Audio IN this tutorial video i will show you On the TDA7313 audio processor using Arduino, you can make a simple but functional tone and volume control. The TDA7313 microcircuit has three stereo inputs, bass and treble tone controls, loudness and four outputs (pseudo-quadro). The control is carried out using I2C. The piping is minimal - several capacitors and two resistors. Nominal supply voltage 9V. by the way TDA7313 same as PT2313 ic Main features of TDA7313 Supply voltage 6 ... 10 V (9 V recommended) SOI no more than 0.01% Signal to noise ratio 106 dB Channel separation at 1 kHz 103 dB Volume control from -78.75 to 0 dB (0 ... 63 levels) Bass and Treble tone control ± 14 dB (-7 ... + 7) Attenuator adjustment independent for each output from -38.75 to 0 dB (1.25 dB step) Preamp adjustment from 0 to 11.25 dB (3.75 dB step) ------------------------------------------------------------------------------------------------------------------------- also used an encoder switch and IR receiver any IR remote you could use just update the code ------------------------------------------------------------------------------------------ shematics code library all files included in -Download Link----------------------- -------------------------------------------------------------------------------------------- IF you have any question feel free to leave a comment and i will be happy to...