Gigabyte X570 Aorus Master - How to setup RAID1 & how to install Windows 10 on RAID from flash driv

Video shows how to setup RAID1 array on Gigabyte X570 Aorus Master motherborad and how to install Windows 10 on RAID consisting of two M.2 NVMe SSDs from a flash drive. It also covers how to create a bootable Windows installation flash drive and downloading proper RAID drivers which are necessary during the installation of Windows 10. Recovery scenario where one of the drives fails is shown as well so that you know what to do if this event happens. RAID1 is also tested in CrystalDiskBenchmark & ATTO Disk Benchmark and the results are compared to a single disk operation. Goal was to find out what are the differences and speed benefits of running RAID1. Components in the video: New updated version of the motherboard is available: + passively cooled chipset heat sink, 16 phase VRMs, USB 3.2 Gen2x2 - has only one LAN adaptor and only one BIOS The links are affiliate. Using them helps my channel and there is no additional cost to you. WARNING! - READ BEFORE CREATING YOUR RAID ARAY a) After creating your RAID array you will not be able to update your BIOS to a newer version without destroying your existing RAID array and therefore losing your data. Your newly flashed BIOS would lose the meta data (information) about your existing RAID array (it would be deleted during the flashing process) and therefore it wouldn´t be able to see your drives as part of it . If you need to update your BIOS to a version which is compatible with new AMD Ryzen 5000 CPUs - do it BEFORE...