(Outdated) Klipper on BIGTREETECH SKR Mini E3 V3.0 (Fix)

I had an issue where Klipper doesn&had an opportunity to compile firmware for STM32 version of a controller that pre-installed on this board. As BIGTREETECH&precompiled Klipper image based on outdated Klipper, FluidPi will complains about version, here is simplest solution for the issue. At the video i used Midnight Commander via SSH to navigate thru pi&linux structure, command to install it (run in ssh session at pi): sudo apt-get install mc I would recommend following an official Klipper repo in order to track update with new board and switch Klipper folders back due to Klipper folder we created is from Bigtreetech&repository. This board was purchased by myself - not a sponsored video. Thanks. I really hope this info will help someone.