Cheap and Easy FT8 Setup for your G90

The G90 has always been a pain to use with digital modes, now with this cable its super easy to get on FT8 (and any other digital sound card mode). This cable will work with Windows, Mac, Linux, Android - I show you how to setup Linux, but the concepts apply to all operating systems. ? NOTE: 10/14/22 If you have applied the 1.79b02 (Or newer) firmware update from Xiegu, you&need to select "U-D" as the mode for FT8 so that data travels out the rear port. Factory Reset- Not required, but proving a point here Hold down FUNC and Power on Confirm with PRE key Pre/ATT off Press CMP - widen BW to 3k NB Off AGC Off Func-On F-L - Spin VFO to fully open the filter F-H - Spin VFO to fully open the filter POW - Set Mic Gain to 10 POW Button - Set Input to Line Func - Long Press VM Button (Next) until you see Aux In, Set to 8, Press CMP (Save) Func - Long Press VM Button (Next) until you see Aux Out, Set to 15, Press CMP (Save) Click the ? Like Button, ? Leave a Comment, ❤️ Subscribe ? Support The Channel ? ? Fun Stuff ? Where possible, all links are affiliate links, this youtube thing is an expensive endeavor and every little bit helps. ? Chapters 0:00 Intro 0:14 Physical Connections 3:09 WSJT-X Install and Settings 4:54 Find your Maiden Head grid square 5:30 Radio Settings 6:02 Find Your Serial Port 8:56 Audio Settings 11:20 Check your time 11:48 It Works! 12:11 Watch your HEAT! 12:54 In-Radio Settings 14:38 Deep...