How to Print LW-PLA (ALL MY SETTINGS) | ft. NEW eSun eLW-PLA

I will show you every line in Cura for all my LW-PLA settings. To print PLA just change the temp to 215c and 100% Flow rates. I will also show the difference between ColorFabb LW-PLA and eSun eLW-PLA. Thank you so much for watching! #ItFlies eSun ePLA-LW: Coming Soon LW-PLA Setting Profile 3 Cura: Quality: Layer Height – 0.25 Line Width – 0.4 Shell: Wall Line Count – 1 Infill: Infill Density – 0 Material: Printing Temperature – 235 Build Plate Temperature – 60 Flow – 55% Enable Retraction – Checked Retraction Distance – 2 Retraction Speed – 30 Retraction Extra Prime Amount – 0.5 Speed: Print Speed – 100 Outer Wall Speed – 40 Inner Wall Speed – 40 Travel Speed – 80 Travel: Combing Mode – off Cooling: Enable Print Cooling – Checked Fan Speed – 20 Mesh Fixes: Union Overlapping Volumes – NOT Checked Special Modes: Surface Mode – Surface Experimental: Slicing Tolerance – Middle Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!