Gerard Morin replication with neodymium magnet 3

Аватар автора
Energizing Evergreens
Ok, so having shown that the adjustment on the readout goes from 800 - 2200, this is just a run to see the un-connected output of the generator. The reading of the voltage runs out before the readout on the "motor controller" reaches maximum, so your guess is as good as mine. I made a video a few minutes after this one, which I will post as soon as this has uploaded, which shows that there is a HUGE difference between running the setup with a 100W light bulb and with an induction stove coil instead....one to watch as it was with the induction stove in the circuit that craziness ensued....

0/0


0/0

0/0

0/0