Altair 4XR Calibration Guide by Ideal Calibrations

This is a video in the How To Calibrate Your Gas Monitor series by Ideal Calibrations. All you need is trusted calibration gas (of course we recommend Ideal Gases brand), a cal cup, a regulator, the adaption fitting, and tubing. If you have a problem during your calibration, give us a call or send it in for repair here: MSA Altair 4XR Calibration Guide: Want to calibrate the MSA Altair 4XR? Here&how: 1. Turn the MSA Altair 4XR on in normal reading mode. Do this by pressing and holding the center button. 2. Once the MSA Altair 4XR is in normal reading mode, you need to send it into calibration mode. Do this by pressing and holding right beeps at you and the screen asks you to zero the monitor (sensor refresh on the MSA Altair 4XR). 3. Now that the screen is asking for confirmation, press the center button once to confirm. This will send the monitor into zeroing mode. Now is a good time to set the monitor down, and grab your calibration gas, regulator, and calibration adapter. 4. Open the valve on your regulator. This is a very important step so you do not ruin your calibration gas cylinder. Now screw it in to your calibration gas cylinder. Close the regulator once you hear gas spewing out of it. This is the signal to know your regulator is good to close. Continue screwing in the regulator until it stops. Do not overturn it. 5. Attach the tubing to the hose barb on your regulator. Make sure the tubing is also connected to your calibration adapter. 6. Wait for the screen to...