Pattern drive Shog Time setting. Tricot Warp Knitting Machine. Karl Mayer. 트리코트 경편기 타이밍 설정 편직 니트 원단

Let&look at how to set the overlapping motion of a general machine. The criterion of the description is the Tricot Karl Meyer machine. Let&look at the gauge chart to match the overlapping motion or timing by machine type. Gauge dimensions vary according to the machine type and motion number. The HKS-2 type is 6.5mm and the HKS 3.4 type is 7.5mm, and there are also 7mm and 11mm type machines. 4 Tempi setting gauges are all 32mm. This is the gauge for each dimension specified in the reference table. The one above is for 3 tempi, and in the middle is for 3 tempi and 4 tempi made by Hanyoung Machinery, and the width 32mm gauge is for 4 tempi. It is of utmost importance to stop the machine at the specified position for accurate setting of the overlapping motion. Only when it stops accurately at the designated position, perfect operation is achieved after setting the gauge. The main shaft has a crank angle key and a pulley lock key. If the angle key is located in the center of the bottom, the cam is 180 degrees and the position may be different depending on the machine type. It is a gauge to check the operation of the crank drive, and it is a necessary equipment to set the correct operation of the unit. If the cam angle reference point key is located in the center of the bottom, you can see that it is 180 degrees on the gauge. Stop the machine at this point. Alternatively, when reaching the highest point of the guide bar lever, the crankshaft is 180 degrees Stop the machine at...