Control four servo motors by Arduino and Sensor Shiel v5.0

Controlling servomotors with an Arduino and a Sensor Shield V5.0 is a relatively straightforward process. Here are the steps you can follow: Connect the Sensor Shield V5.0 to your Arduino board. Make sure that the power switch on the Sensor Shield is turned on. Connect the servomotor(s) to the Sensor Shield. The servomotor should have three wires: red, black, and white (or yellow). Connect the red wire to the 5V pin on the Sensor Shield, the black wire to the GND pin, and the white (or yellow) wire to one of the digital pins on the Sensor Shield (for example, pin 8). Write your Arduino code. Here is an example code to control a servomotor. Upload your code to the Arduino board using the Arduino IDE. Watch your servomotor move according to the code you wrote!