NETGEAR WNCE2001 Universal WiFi Internet Adapter Initial Setup

This device goes from WIFI to RJ45/Ethernet Quick Start Guide for Netgear WNCE2001 1. Connection the supplied Ethernet cable between the WNCE2001 and your computer, and connect the power cable (A/C adapter or USB). This computer should be connected to your internet connection but disconnected temporarily during setup (WIFI off etc) 3. If prompted, your username: admin and password: password. 4. Follow the on-screen prompts to select your wireless network and enter security information. 5. Complete set-up, disconnect the WNCE2001 from your computer and connect it to the device you wish to receive a wireless signal on. 6. Side note: make sure all connections are restored if your internet was disconnected per the instructions in Step 1. 7. For firmware updates and additional advanced configurations, please plug the WNCE2001 back into your computer, and wait for the Wizard to pop up.