arduino cannot get sync || avrdude: stk500_getsync(): not in sync: resp=0x00 error Solved

zip password - subham123@ steps - 1. Disconnect your Arduino from Power and USB. 2. Put a Link on the ICSP1 and short pins 5-6. 3. Connect USB cable. 4. Remove the ICSP1 5-6 Link. 5. Start FLIP software. Go to: Start All \Programs \ Flip \ Flip. 6. Go to: Settings \ Communication \ USB. 7. Click to Open. 8. Go to: File \ Load HEX file. Select this file 9. Press Run. 10. Disconnect USB cable and connect it again. 11. Go to Device manager Win+Pause \ Hardware \ Device manager and check if the driver was loaded correctly. You should see it under Ports \ Arduino Uno 12. Great! We can now test a Blink example. Start Arduino software Start \ Arduino. 13. Click on the “Open” icon arrow Up \ 01.Basics \ Blink. 14. Select COM Port: Tools \ Serial Port \ COM select the port where the board was recognized. 15. Click to “Upload” icon arrow Right. 16. The user LED should start blinking