Use Dragonframe software to control stepper motors with Arduino and CNC Shield controllers

Аватар автора
Велоконкурс
I will show you how to connect the parts, install the Arduino sketch and configure Dragonframe software to control a Nema 17 stepper motor. Links to other videos about pan tilt slider examples that I used along the way: How to mechatronics: isaac879 Dragonframe to CNC Shield setup: Biolapse Studios: Different stepper drivers but still helped a lot CNC Shield Parts: CNC Sheild instructions: Arduino sketch I used - worked for me without any modifications needed: This is the key to getting Dragonframe working with the CNC Shield Thingiverse CNC Shield Mount:

0/0


0/0

0/0

0/0