How to empty the bin on your Dyson Cyclone V10™ cordless vacuum

Dyson Cyclone V10 vacuums include a new point-and-shoot bin emptying mechanism. This hygienically drives out dust and debris in one action. There’s no need to touch the dirt. Take care to empty as soon as the dirt reaches the level of the MAX mark – do not overfill. Make sure your machine is disconnected from the charger before emptying the clear bin, and be careful not to pull the &trigger. Remove the wand by pressing the red wand release button and pulling away. To release the dirt, hold the appliance with the bin in a downwards position then firmly push the red bin release button. The bin will slide down, cleaning the shroud as it goes. The bin base will then open. Please note, the bin base will not open if the red button is not pushed down fully. Our experts are on hand to help, so leave us a comment if you&like some further advice. Step 1. Empty as soon as the dirt reaches the the level of the MAX mark - do not overfill. Step 2. Remove the wand from the bin assembly. Step 3. Hold the machine with the bin in a downwards position, and firmly push the bin release lever. Step 4. Do not pull the on trigger when emptying the bin. Step 5. Press the button located on the bin runner to release the bin and slide the bin off the runner. Step 6. Clean the clear bin with a damp cloth only. Step 7. Ensure that the bin seals are complete dry before replacing. Step 8. Insert the spine into the bin runner. Close the clear bin by pushing the bin base upwards until the clear bin...