Royal Enfield Meteor/Classic/Hunter 350 Valve Adjustment & Service | Oil Change | Tappets

Hello and welcome, today I&performing the 310 mile first service on my wife&2022 Royal Enfield meteor 350. I will be covering tappet adjustment and oil and oil filter change. I have time stamped each process. I do encourage owners to work on there machines because it gives you a better connection of the motorcycle, however I cannot guarantee this will not effect your warranty, but please proceed at your own risk. Remove the rear back rest screws using a 6mm hex bit remove the side rails with a 9mm hex bit slide the rear set off with a 10mm socket remove the rider seat remove the tank bolt with a 8mm and 10mm socket its a good idea to do this with an empty tank gently lift the tank and slide back, get an assistant to hold the tank up un plug the main fuel line, it has push clips either side remove the rubber cover around the fuel pump plug, with your finger push the tab inwards and pull the plug go to the right side and remove the 2 breather hoses, one is bigger than the other lift the tank and put it in a safe place remove the rocker bolts with a 10mm socket, start from left to right remove the coil unit by unscrewing the 3 bolts, use a 10mm socket, there are 2 earth wire the go through 2 bolts gently lift the rocker cover, leave the gasket on the cylinder block grab a 14mm hex bit and unscrew the crank screw cap make sure the seal stays in the screw cap remove the spark plug with a 16mm socket check spark plug gap, it should be between 0.7mm and 0.8mm you dont have to do...