BUILDING an AMAZING DC-6/DC-7 Airliner | Full DIY Build & Flight

Build Volume required for this airplane is 200x200x200. RTF weight: 3,600g Wingspan: 1.8m Length: 1.6m Print time: 150hrs 2kg of PLA Thank you so much for watching! See what else I am working on: #ItFlies Here is an rcgroups build thread: Amazon Shop (ALL PARTS listed in one place): DC-6 Parts list: 1x 1300mah 2s Receiver Battery: 3x 3mmx45mm Screws for wing to fuselage mount 3D Printers I use and recommend: Printer Setting on Cults page 00:00 Building an AMAZING DC-6/DC-7 Airliner | Full DIY Build & Flight 01:27 Fuselage Assembly 05:44 Tail Assembly 06:59 Adding Servos to Rudder and Elevator 08:48 FLSUN V400 3D Printer Review 09:28 Wing Assembly 10:33 Assembling Flaps, Ailerons and adding Servos 12:40 Nacelle Assembly 14:15 Setting up the Multi Engine Brushless Motors and ESCs in the wing 15:54 How to add Retractable Landing Gear 17:02 Fuselage and Wing final assembly 18:51 3D Printed DC-6 Preflight Checks 19:14 Decals 19:59 Spektrum Smart Tech Lipo Batteries 20:38 RC DC-6 Maiden Flight 22:52 Do 3D Printed planes fly? Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!