CR Touch Install Guide – Complete Walkthrough!

Auto bed leveling is an excellent upgrade to any 3d printer. In this video, I go over how to install and setup the new Creality CR Touch auto bed leveling kit on an Ender 3/Ender 3 Pro with a Creality 4.2.2 mainboard, the process is the same if you have the 4.2.7 mainboard. I walk you through all parts of the process, including installing the hardware, upgrading the firmware, and making the necessary changes in Cura to allow it to run at the start of each print. If you have any questions on the content covered in this video, feel free to leave a comment below with them. I try to reply to all commented within 48 hours Resources Hardware Software Other Videos Need Assistance? Our Site